Lynx Fairings Fitted to the Husqvarna TE 610 and TE630
The Lynx is ideally suited to both Models allowing the owner to fully use the capabilities of the powerful motor at elevated highway speeds.
- Most of the installation work is focused on the relocation of the OEM instruments onto the Lynx dashboard. The 630 dashboard is pre-drilled to accept the Speedo and also for access to the ignition switch.
- The 610 dashboard comes plain and it is recommended to locate the ignition switch onto the side of the Lynx dashboard.
- The dashboard on both models is attached to the top triple clamp under the bar risers.
- As with all Lynx kits, ample room has been left for the owner to install a GPS unit above the OEM instruments along with any other switches and sockets etc.
Installation time will vary depending on the complexity of the owner’s dashboard layout, but at least 4 hours should be allowed to complete the process. Owners are also encouraged to inspect the installation instructions before ordering.